Hot Knife, Hot Foam Cutter,280W Foam Cutter Electric, 0-550℃ Polystyrene Cutting Tool, Portable Hot Knife with 3 Blades for Sponge/EPS/EPP/KT Board/EVA/PU/Fabric/Rubber

This is a great tool. The temperature control slows you to get it just right for different materials. It’s only hot while you are holding the trigger so is safe to leave sitting between cuts.

This heat knife as saved me a lot of time and mess, very sharp blades which get very hot, just slices through polystyrene insulation with ease. I have even used it cut through drain pipe with ease. Well built with great quality and value.

Great foam cutter, I used it to cut the foam inside a large case, that my pistol fitted in, then I lined the case with some crushed velvet. Very pleased with the result.

In the past I’ve tried cutting polystyrene with a basic knife. Not a good idea as you get bits of statically charged polystyrene everywhere. So this cutter interested me. You get a number of different blades the heat gun an Alan key and a coper wire brush. The system for attaching the blades is quite basic but works well enough, just unscrew the contact plates with the Allan key, slip the blade end under the contact plate and tighten. When using the cutter it remains quite cool. The heated blade cut through the polystyrene with relative ease, but starts to snag after a while so take is slow and easy and your fine, cut too fast and it will start to tear rather than cut, The blade melts the polystyrene as it cuts, so you get a coating on the blade and thin hair like strands. The set includes a copper brush to clean the blade afterwards, but the quality of the brush is poor quality and I believe will need replacing in time. Although you don’t get a case as such with the set, the box it comes in is relatively strong carboard box which internally has cut out holes/slits in foam to hold the contents. I would definitely keep the box for storage, you can however lift out the foam innards and use it in a draw etc. Instructions are poor with no mention of the temperature control wheel or red LED. I haven't had the need to cut foam as yet, but have no reason to doubt its ability to do so.

Blades would not get hot, though light on device lit and the device itself got warm. Returned.

Works like a charm. Bought it for cutting plastic and various DIY jobs around the house and it has been wonderful.Looks durable and built with quality. Just remember to clean the melted plastic off the blade with the metal brush :)

Does the job required

The hot wire foam cutter is equipped with 3 nickel-chrome blades: 1 curved blade of 5.5 cm, 1 spatula blade of 5.5 cm, and 1 blade of 25 cm, along with 1 Allen key and 1 cleaning brush. It meets various usage needs.The knife heats up quickly, within 3-5 seconds. The 300 W knife can reach temperatures ranging from 0 to 600°C.The built-in temperature control system in the hot wire foam cutting device, advanced air cooling system, and ventilation holes prevent overheating and extend the device's lifespan. It is suitable for commercial and industrial applications, including cutting larger quantities of materials such as medium- and low-density foam, nylon cords and strips, light foam, KT board, polyurethane, polyethene, EPS, XPS, EPP, EVA, EPE, PU, polyester foam, sponge, rubber, etc.It was very useful during the renovation of the gazebo, and my husband was pleased. :)