Beduan PU Transmission Round Belt 6mm OD High-Performance Urethane Belting Green for Conveyor Bonding Machine Dryer 16.4 Ft

You need to be able to melt the ends together and trim away excess. If you are comfortable with that, this is a great product.

The media could not be loaded.  This belt is oversized for the pulleys on my 9x20 lathe but let me tell you, I put a 6” 3 jaw chuck on the lathe and it works great! No squealing, I can do all operations including threading. Very easy to splice together, I use a heat gun and it’s strong. I have a more powerful lathe with less money than the original belt. Can’t wait to use it on a tool post grinder.

I use this on my sewing machine. Good quality, easy to make joints as long as it's clean, and not over heated!

Needed to replace a broken belt on a labeling machine.This looks like it will perform well.

The belt material fuses beautifully using the "shaft", not the tip, an old soldering pencil. Unfortunately I believe the small pulley on the tumbler motor causes a bend that exceeds the minimum diameter recommended & the belt breaks after a few dozen hours of use. The heat of the motor, which normally runs hot to the touch, adds to quickly further weakening.

I couldn't find the two 20" narrow belts I needed for a 1950s Black & Decker valve grinding machine. I purchased both the 6 & 8 mm belts. Both work, but wish they made this in 7mm. Following the directions, these are very easy to melt together and I tugged pretty hard and couldn't pull them apart. I used a soldering gun with a round flat attachment to heat both ends of the belt at the same time. Quickly, I mated both ends in a V-block which perfectly aligned the joint. Then I used a bench grinder to grind the joint flush. We shall see how long this belt lasts. If you can't find the right size belt for your application, this is a cheap fix. I would purchase again.

So far I am pleased with this product, I used it to fabricate a belt for a 70 year old metal lathe. With all the belt manufactures making it difficult to know the actual belt length. This product makes it easier to get a machine running again, also saves time and effort just installing a belt.

I needed a small transmission belt for a project and found the following features of the 4mm belt that I didn’t see in the product description: It is slightly stretchy - I needed a belt that was one foot long before joining the ends. I subtracted about 1/2 inch and found it fit around two pulleys with a nice amount of tension. I was also pleased that the belt surface was not smooth and slick. It has a slightly abraded finish that helps prevent slippage. This product fit my requirements perfectly.

very good product thanku