Nilight 2PCS 16 AWG 10 Feet Wiring Harness Extension Kit for LED Work Light Bar Led Pods Off Road Lights Driving Fog Light Boat Lighting, 2 Years Warranty,black

Very easy to install

I had a set of 3” Nilight pod lights with wiring harness to install as rear lights on my Ranger 570 SP. The Nilight harness with relay was great! But it was too short to keep the relay and fuse in the front compartment on the pulse panel. These were the perfect solution!The extensions are plugged in under the tunnel to each of the individual light leads from the Nilight harness. And there was just enough length to run behind the seat back, up the driver side roll bar, and to each light. (Had about 1’ too much for passenger side light, so should be fine for full-size Ranger too.)Now have a weatherproof, factory quality installation with no splices or solder joints. The only mods I had to make for the entire install (not related to these extension cables) were: 1) Cutting the ring lugs off and adding waterproof heat shrink butt splices to Polaris pulse plug, and 2) Buying a factory-style Carling L1 illuminated switch to replace the round switch provided. (This is a direct plug and play too since the Nilight switch wiring has 1/4” faston connectors.)

Extention works well with the light I put In bumper of my 2016 ford escape

Very nice extension wires. Sheath is tough and the connections are tight. Very easy to install. I ended up to tuck in the wires instead of cutting because it was a little long for my application. Works great and had no issues. Pair the wires with my Nilight light pods. You can buy the wire but this was easier and cheaper than getting the wire and sheathing separately.

nice cables.... 1/4" spade fit tightly on speaker terminals. nice durable plastic covering. lay in the sun to warm up and they straighten right out

Super easy to hook up following the instructions no problem very good connections highly recommended you cannot go wrong with Nilight 👍👍

Buen material resistente lo usé para mi faros lec

Good value, inexpensive way to extend other wiring. Decent materials and seem close to OEM.