Hopkins Towing Solutions 48265, 4 Flat Trailer End Y-Harness (30') Connector

Well made, 1/2 the price of local.

This was the thicker wire, unsure what gauge and the ground wire was thicker than the rest of them. I found it a higher quality wiring harness than the "Made in China" harness that was available at the local trailer store. I would buy again. I wired a 6x12 foot utility trailer and had to cut off about 6 feet of wire. So for my application the wiring was plenty long.

Very easy to install. I used trailer wiring clips that are also sold by Amazon. I found it much easier to connect the wire through the clips before attaching the clips to the trailer. I also used the butt connectors that have the solder and shrink tubing already combined. Simply trim the wires, push them into the butt connector, then hear the whole thing with a heat gun until the solder melts and fuses the wires. Then continue to use the heat gun to continue shrink the attached tubing to make a waterproof connection.

We ordered this and it was defective. Contacted seller and sent replacement over night. Wasn’t able to use for trip but was easy to install and replacement worked great!

The wiring harness worked great until one day after a year a couple of the wires corroded right at the four pin connector.

I am getting tired of having to rewire my trailer every year or two due to cheap wire kits. This time I did some research before ordering and I am very happy with this wiring kit. Thicker gauge wire than others and seems durable. Only time will tell but the quality is much better than others I had purchased in the past.

This wiring kit is a great way to rewire a trailer. It is 35 feet long and is separated right and left side. No separating the wires to feed each side lights. No cross feed wire needed. I rewired a 16 foot boat trailer in about an hour. These connected to the lights and worked right out of the package. I recommend it to anyone wanting to rewire a trailer.

Honestly, this is the only way to wire up a trailer. The wiring harness has two brown (running lights) wires so there is no need to splice a wire between left and right side. It means you can run the wires down the length of the trailer, one group on each side, connect to the rear lights and be done. I had one splice for a running light in the middle and used a posi-tap stuffed with dielectric grease. For the rear lights I used heat shrink connectors and a bit of dielectric grease for good measure. The wiring is high-quality stuff, very flexible and feels like it will last for years and years. The only small complaint is that the white ground wire should be about 12" longer.

Good quality wire harness. I like the double brown wire, it works out great for what I needed. I have recommended this to others.

Beaucoup trop cherJ'ai trouver le lendemain à 12.99 chez mon auto parts a coté de chez moiMais sinon excellente qualité