Iverntech 6pcs 1M XH2.54 4 pin to 6 pin Terminal Stepper Motor Cables for 3D Printer Nema 17 Stepper Motor

Had to replace a 3d printer motherboard which required different length cables.These did the trick much easier than me breaking out pins and crimpers to make custom cables.Working fine to drive a Tronxy X5SA Pro at > 450mm/m travel speeds with klipper on an MKS Robin Nano v3.1

Nice Quality. Works perfectly, used it to add a rotary roller to a K40 engraver with GRBL controller.

Perfect for what I needed it for.

I bought this thinking it was a 1-1 swap for my ender 3 pro. You need to swap the 2 middle pins on the 6 pin adapter. It took me a bit to figure out why my upgrade didn’t work. Other than that it works perfectly fine!

PSA: swap the green and red wires on the end of the wire that goes into the stepper motor. Push down on the little tab on the top of each pin to release it from the connector. I didn't do this, and it made a terrible knocking sound. My poor stepper.

I needed to have some extra parts on hand for my 3D printers so I picked these up. Already had to use several of them. You just never know when something is going to break so these are good to have on-hand just in case.

I ordered this to replace the damaged cable for my Creality CR-10S Pro v2. The cables were just the right length and replaced the stock z-stepper cable without need for modification. Best part, for about $10, I have spares (a printer design and fatigue issue, not the cables).

They work, but I had to swap the two middle wires to get them to work on my Ender 3 pro. Since I don't have a way to extract the pins I had to cut the wires and cross solder them.