D3536 Brushless Outrunner Motor 910KV RC Electric Fixed Wing Motor for Aircraft UAV Mini Multicopter RC Plane Helicopter Robotic Arm

Delivery was faster than expected, motor has more tourk then needed and plane is almost never Flown past half throttle. Will buy again when needed.

Got the 750kv to replace an eflite motor that burned up. Eflite bolt pattern is weird but made it work. Went from pulling 70 amps on a stock 60 amp avian esc on stock motor and constant overheating to pulling 30 amps with esc temps below 90F vs 130F+ with eflites motor. Solid motor at a respectable price!

The media could not be loaded. That was just the title, didn't mean to send it 😆. I had destroyed a brand new motor and had to rebuild the plane. A friend of mine in my flying Club told me of this motor! I trust him as he builds a lot of planes. How can you beat this price? I found the performance to be at least as good if not better than original equipment! It has enough power that I could go up a prop size according to specs! I will get back to you on that, very pleased, highly suggest this motor for replacement and hobby building to your choice, great motor!!I bought a second for my Valliant. I will most likely but a 3rd for my glider. Highly recommend, the description on the motor doesn't affect the quality of the product itself.

Good power

Purchased for 3D printed 1:8 expedition/scaler car, has been running for probably over 100km without issue - it appears a few mm shorter in length than what the model is designed for and has only 3 mounting bolts, so minor modification was necessary.

Works perfect. Running a 4s on a 9x6 prop and 60 amp speed control.

Purchased in January 2014. With very little running time the engine started making noises and stopped rotating. Flew this engine at 50% throttle.

this is the fourth one of these I have bought. on three of them I could only find three of the four screws to mount motor to X mount. I did find it stuck and I mean stuck in the prop adapter. after about five to ten min. of pushing it back and forth with an x-acto knife point I was able to get it out . the threads were probably useable but were messed up enough that i used a spare I hadas far as the motor after an initial hick-up or two they run great with plenty of powerdo be aware prop mount hole is 8mm.