Nilight Trailer Hitch Extender 18 Inch Extension Length Fits for 2 Inch Receiver Tube with 5/8 Inch Stainless Steel Bolt Flange Nut and Clip 3,500 LBS GTW Matte Black

Just what I needed. Four inch drop for my tow bar hookup and a second receiver for my bike rack on the RV. Good quality welds, fit and finish. No issues.

This is very heavy duty well built hitch extension, the extension part is well built, vs some other brand, this one is solid instead of empty. You may need clamp, .

Lifted the rack to clear the ground to keep from bottoming out.

I LOVE this drop hitch. It aligns the toad hitch exactly. Love the bolt and nut to tighten it up and also the drilled hot for the spring pin as a backup.

as others have noted, this runs 1/8 to 1/4 inch larger than a standard 2” hitch. This means the trailer, bike rake, or whatever will rattle or knock in a turn. There are items you can purchase which tighten this up if you don’t plan to swap your hitch often. -1 star for not being the right size.With that out of the way, this is built quality and is a lifesaver when my kids want to bring their bikes along with whatever I’m hauling. My first use of this was a 800 mile road trip. I arrived at the destination and all items were attached, so all in all this works just fine!

I wasn’t sure this was going to come in time for our trip, so I also ran out to harbor freight and bought one there. Our bike rack was 1 3/4in but the trailer hitch was 2in. The one from harbor freight was flimsy and made the bike rack jiggle around. This one was perfect, fit snug, with significantly less rattle. I’m very happy with the product

This thing is actually pretty great! I didn't even know a double receiver existed until I had the need arise and I found one at a big box hardware store. This one is constructed the same... it is really well made and heavy. Thick steel. The price is a lot better than the one I had seen in the store, and I sacrificed absolutely nothing as far as quality, while keeping some green in my wallet.

This review is specific to the “Receiver with 2" Rise or Drop with Bolt Nut Clip 7,500 lbs Capacity Adjustable Extend 5" 7" 9" Length Matte Black Powder Coated”, which I think has a defective design for only the 5” length hole, which is what I wanted to use. The 5” hole is located about 1/8” to close. Between the hole location and the weld for the riser, the pin will not go through the 5” hole. It works fine for the 7” and 9” hole locations. It took me an hour to drill out the solid steel shank to get the pin to barely go through the 5” hole. They need to redesign this to move this hole slightly farther back so the pin will fit properly.