🔗 Connect Like a Pro — Don’t Let Signal Slip Away!
The BINGFU SMA Male Crimp Solder Connector is a 50 Ohm gold-plated copper coaxial connector designed for low-loss, high-performance signal transmission. Compatible with multiple coax cable types and a broad spectrum of 4G LTE, wireless, and RF devices, this 10-pack offers versatile crimp and solder attachment methods, making it an essential component for professionals and tech-savvy enthusiasts aiming for reliable connectivity in demanding environments.
| Number of Items | 10 |
| Item Weight | 0.03 Kilograms |
| Unit Count | 10 Count |
| Shape | Round |
| Color | SMA Male |
| Indoor Outdoor Usage | Outdoor, Indoor |
| Recommended Uses For Product | coaxial cable connection, 4G LTE mobile router, cellular gateway, vehicle car truck RV bus van mobile cellular, 4G LTE cellular trail camera, game camera, outdoor security camera, industrial 4G LTE router, cellular IoT gateway, 4G LTE M2M RTU DTU terminal, WiFi router, USB adapter, wireless AP hotspot, WiFi signal, wireless mini PCI Express PCIE network card, IP security camera, wireless video surveillance monitoring, FPV drone controller, FPV camera, wireless backup camera, rear view camera, RTL-SDR USB dongle, ADS-B receiver, ham radio, amateur radio, GPS navigation antenna extension cable |
| Data Transfer Rate | 50 MHz |
| Number of Pins | 1 |
| Connectivity Technology | Coaxial, USB |
| Connector Gender | Male |
| Connector Type Used on Cable | USB Type A |
| Cable Type | Coaxial, USB |
| Compatible Devices | Television |
| Outer Material | Copper |
B**S
Nice quality connectors
I needed to shorten an AM/FM antenna cable that I was installing on my motorcycle. The provided 6-foot cable was just too much to bunch up and tie-wrap down. This connector installed very easily. Comes with everything you need including the heat shrink to finish it off nicely. You will need a crimping tool to put on the collar. I was able to solder the pin to the end of the wire very easily. I’m very happy with these SMA connectors.
T**Y
They worked out great on the cable I used.
No issues with them at all. Did a fine job.
G**E
Needs instructions!!
I would have though that the connector was supposed to be pushed down over the ferrule until the jacket meets the nut BUT if yo do that with RG58, the crimp sleeve won't fit over the jacket. So first slide a piece of heat shrink tubing (not included) double the length of the crimp sleeve over the cable, then trim the jacket back 12mm, trim the braid back about 5mm leaving 7mm, then trim 3 mm off the dielectrc to expose the center conductor. Solder the center conductor then push it into the shell until it's just slightly shorter than the connector rim. At that point, the braid should be touching the connector nut and the jacket should be touching the end of the ferrule BUT NOT SLIDE OVER IT. The crimp sleeve only crimps the braid to the ferrule, NOT the jacket. Crimp the sleeve, then slide the heat shrink over the crimp sleeve and shrink.
R**B
Worked OK
I was able to crimp the connector and it worked just fine
D**.
Good quality chassis mount for bulkhead SMA projects
Cheap, yet good quality for a bulkhead solution approach.
M**
Diameter too large.
Does not fit rg8x
M**.
Fast service.
very good quality at a fair price.
C**N
work fine
bought for work since going through channels takes to long, connector works fine for RF work I am doing.
Trustpilot
2 weeks ago
3 weeks ago
