WaveEater Power Valve Clip and Couplers Kit - for 1200cc & 1300cc Yamaha WaveRunners

Clips fit great, these are the original proven design, not the cheap clips that have to provision to keep the Allen screw from backing out. Couplers are well thought out, however they were a very tight fit on the power valve shaft on my '02 GP1200R. There is zero play in the power valve system now. I encourage everyone to double check their cable rigging after the install in accordance with the factory manual, it takes no more than 10 minuets to verify using the 4mm hole Yamaha provided in the pulley. I also added 4 oetiker clamps on the barrels to prevent the roll pins from ever falling out.

I have three 2-stroke 155 hp Yamaha Wave Runner PWC's that will each go 65 mph.Wave eater clips are a necessity. Your power valves can disappear into the engine without them. If your Yahama power valve PWC doesn't have them, get them installed asap.

Nothing like a little assurance that if something happens to a power valve you aren’t out a cylinder.

Fit as promised. However the instructions for the couplers was wrong. Went to their website where the instructions were right. Just be carefull when installing the clips that the cables don't come out of the wheel.

Great parts came with stickers 2x of them

this is a must have item for your GP1300R power valve engine

Purchased these for both our XLT1200cc Waverunners. Install is super easy for both the clips and couplers. Just don't drop anything into the hull!

Fit fine works grwat