KeylessOption Keyless Entry Remote Car Key Fob Uncut Key Blade Shell Case Cover for Pontiac GTO (Pack of 2)

Bought two of these to refurbish my two keys, have used one so far, and it works perfectly and looks great! A note though: you're buying the plastic shell, uncut blade, and two screws to hold everything together, and that's it. If you need anything else--a new seal gasket, electrical contact to the blade, anything--you'll have to buy more than this. If this is all you need though, it'll work great!

Original key 2004 GTO very difficult to open without damaging so I only did one transfer. Once I transferred all components over key fob buttons are very sensitive. Not sure how a 20 year old battery is still working in both fobs.

My old GTO keys wore out after 14 years (buttons wore out and came off) couldn't lock or unlock doors anymore. I thought I'd be stuck paying hundreds of dollars at the dealer. Found this pack of 2 for $9.95 and decided to go for it. Worked great. Just pried apart the old keys and swapped out the guts into the new keys, and used same cut key for ignition. I'm a happy camper. Read some other reviews about the buttons being too long and touching the switches inside, so I just trimmed like 1/16" off the rubber part of the bottom of the lock/unlock push buttons and it works great.

Used a Dremel with a fine cutoff wheel and followed the groove around the old FOB. Did not cut all the way thru. Then followed up with a screwdriver and a slight twist around the peripheral and the case popped apart! Take care pulling the silicone o-ring out as you reuse it. Disassembly of old took about 5 minutes and all went back together perfectly. I never leave reviews but after fixing both our $$$GTO fobs for $12 I need to say something. Thanks for having this available. Very happy customer (and wife)!

I like the revised design. No need to bond the halves together like the OEM part. However.....the little stubs on the back of the pushbuttons are too long, so i had to find a way to shorten them so they would not activate all the microswitches 100% of the time. That part was highly annoying. A lot of trial and error to go through. Once that was done, though, they work very nicely.