Gear Shifter Knob Adapter Mod for Logitech G29 G920 G923 G27 G25, Stick Lever Shift Extension, Sim Racing Gaming Accessories [4.5cm (1.77")]

Works great. Uses a screw on the ball and an interference fit for the shaft.

I mean the title pretty much says it all. When it comes to the Logitech G29 and its goofy, sad, plastic shifter most mods require some form of intense install or modding. This? Not at all. All you do is take the stock knob off and slide this thing on, no hardware required. The fit is tight and shows no sign of loosening or falling apart. You can then either buy an adapter to stick a real shift knob on it or screw the Logitech's stock knob back on and you are good to go. It's a simple product that does exactly what it says it will do but it makes a really big difference in the feel and usage of the G29 shifter. I would go so far as to say that if you have a G29 or any other Logitech wheel and shifter combo this is a must have product.

The material isn't the best after putting the screw in the top. It snapped right at the end of the bolt on an average shift in ats I would not recommend this product

It's a great size and makes the stuck shifter feel more comfortable with the additional length. I highly recommend it anyone who wants a different feel on the through.

🫡💯

This was really inexpensive it didn’t cost much so I didn’t expect it to be made of diamonds lol. Surpisingly I’ve had this thing for a good 6 months before it finally snapped, which was rather impressive for a small piece of plastic.Product was exactly as advertised and did fit perfectly no wiggle room.

I'd rather it slid over the shaft and used a setscrew because it is a press fit, and I don't think I will be able to remove it if I need to take the shifter apart. Other than that, it works great. You WILL lose a lot of "feel" in the shifter, so I recommend using the shim mod on the detent spring FIRST. I also feel like my shifter is too high now and need to lower it.

Works great