Thinner DB37 Solderless RS232 D-SUB Serial to 37-pin Port Terminal Male Adapter Connector Breakout Board with Case Long Bolts Tail Pipe

A bit pricy but easy to use.

Very good quality, needed it for my Megasquirt 2 Fuel management system 2.2v board

Worked great for replacing IBM 4869 connector someone had cut off!

It is a little large for a 9 pin but works great.

great stuff

Well made with solid connections.

Used this to connect the tally light interface to a Sony FB80 CCU and it works gloriously. A little trickery with figuring out which wire needed to go where, but it made it easy because of the screw terminals.

The first order I received the frame around the pins was bent so bad that it would not go onto a female DB37, and it was not just the frame that slipped over the plug or I would have just bent it straight, it was the whole metal part that was bent. I could see where this could happen, I do not think it was a shipping issue so I order a replacement.In the second order, 2 terminals on one of the connectors did not have the internal clamp that tightens/loosens with the screw on the terminal leaving me with a 35 pin verse a 37 pin connector. If anyone thinks they may have this issue, you can test by trying to remove the screw on the terminal all the way. If the terminal has the internal clamp the screw will not come out. If the internal clamp is missing the screw will come out of the terminal.On a good note, the connectors do include a ground pin, not included in the 37 pins. The ground pin grounds the metal frame on the connectors which it a helpful inclusion.Like I said in the title, for me these are a great no solder option, but the implementation is not quite good enough.