🚀 Upgrade Your Ride with Confidence!
The SYLVANIA Load Equalizer is a 27-watt device designed to prevent hyper-flashing and bulb-out warnings when using LED light bulbs. It features easy installation, a high-capacity heat sink for lower temperatures, and is compatible with most vehicles, ensuring a reliable performance backed by Sylvania's century-long reputation in automotive lighting.
| Manufacturer | Sylvania |
| Brand | SYLVANIA |
| Model | LOADRSL.BP2 |
| Product Dimensions | 7.94 x 10.16 x 7.46 cm; 90.72 g |
| Item model number | LOADRSL.BP2 |
| Exterior | Machined |
| Manufacturer Part Number | LOADRSL.BP2 |
| Position | Right |
| Bulb Type | LED |
| Special Features | Voltage 12V, Wattage, Base |
| Wattage | 12 watts |
| Item Weight | 90.7 g |
D**5
Seem like good quality
I needed to replace the previously installed resistors (another brand) for my rear turn signals when they began to hyper flash. These were easy to install and fixed my problem.
D**Y
Corrected the Jeep blinker speed issue
Used these to correct a hyper blinking signal light issue when switching to LEDs in a 2013 Jeep Wrangler. Goes between white with yellow strip and black.
J**.
Stops hyperflashing
Easy to install, works good
K**E
They work
Needed one of these for the reverse bulbs in our 2018 Equinox to function properly. Easy installation and the builbs work perfectly fine now. They are made in Taiwan not China so hopefully they will last a long time.
T**Y
Works but requires a good location for placement.
I bought these in order to eliminate the computer error code for my brake lights that is generated by using LED instead of higher wattage halogen. To that goal they work great. Unfortunately, these things get incredibly hot so one would need the proper location to place them. I fully believe they would melt any plastic with which they come in contact and might even start a fire if contacting the right material. I found a place inside the steel wall of the vehicle that worked but one should look and identify the best location prior to purchase. If a proper location cannot be identified , I would not use this. The wire leads are about 4-5 inches on each side and the resistor and heat sink are maybe 3 inches for reference (might be slightly off). Also, the clips they provide to connect the wiring are horrible. They seem super cheap. Just clipping them as shown was not enough to pierce wire coating and make contact with the coper. I had to use pliers to squeeze the halves together in order to accomplish this as well as secure the wires together (so the wires did not just drop out of the clip). A better design here would be money well spent. One might consider getting their own clips to connect the wires. Lastly, they include two plastic zip ties. They don’t reference why (at least what I read/saw in the instructions). I would not use these to secure the heat sync/resistor. If one mounts these as recommended, I would only use a screw into metal (and make sure it not an exterior car panel)
Trustpilot
2 weeks ago
3 weeks ago
