



⚙️ Elevate your HVAC game with Denso’s precision-engineered receiver drier!
The Denso 478-1500 Receiver Drier is a compact, lightweight HVAC component made with durable cloth material, designed for center placement to optimize air and filter drying. Manufactured by Denso, it guarantees reliable performance and longevity in heating, ventilation, and air conditioning systems.

| Manufacturer | Denso |
| Brand | Denso |
| Model | Receiver Drier |
| Item Weight | 8.4 ounces |
| Item model number | 478-1500 |
| Is Discontinued By Manufacturer | No |
| Exterior | Machined |
| Manufacturer Part Number | 4781500 |
| Position | Center |
J**D
Fit and function
It was tough getting old one out but this one fit and works perfectly
M**S
Good fitment
Fits exactly for Toyota Camry 2009 Installation is very easy
H**O
Made in Japan
2010 Toyota Camry SE with 2ARFE engine, 6 spd AT. Same fit. The new replacement filter is slightly wider but it goes in and out just fine. You'll need a special to tool to unbolt the old. Do not over tighten. And you'll need to pull vacuum until the low side is reading ~28in/hg on negative red side. Both sides must be opened when pulling vacuum otherwise your brand new dryer goes bad again. Taking out is not hard but you need to remove a lot of stuff until the condenser is freed from radiator. I had to change out the compressor so I took out condenser. However, if this is your regular MX you can get way with removing 6x 10mm radiator support, remove 2x 12mm horn, then 4x 10mm condenser to radiator bolts. Now you have direct access to remove condenser by crawling under the vehicle.
W**N
Excelente producto, nuenaxbarca original, lo recomiendo .
D**E
Might as well replace the drier while servicing other components in an older car.
I replaced the drier pack while servicing an AC system in a 2011 Sienna. A local repair shop evacuated the refrigerant. I removed the plastic lower engine shield and a few mounting brackets on the condenser to gain full access from underneath. A 14mm hex bit is required to remove the cover. Pluck out the old pack, insert the new one, coat the o-ring(s) with PAG oil equivalent and torque to 25 INCH pounds/2.9N*m. Put your system under vacuum to check for leaks at connections.
F**D
2004 Toyota Sienna AC works !
Get this if you need to work on your AC, worked great for 2004 Toyota Sienna. Got this with a new Denso Compressor. Still working good after way past a year. The old one removed was so soaked with grayish dirt and very wet. ( If I service the AC in a few years I will change this again, since the drier was so soaked and dirty.)
C**V
Fits like OEM
This was the original silicate that was installed in my OEM condenser and so it fit perfectly and works great, value for what you get is not bad at all.
J**S
Different end cap screw on a 04 sienna le
The filter was the same size as the one that was in the condenser. The only problem was that the screw cap was not the same as the one that was in my 04 sienna. I did replace the condenser a couple years ago so I'm not sure if they updated the condenser. I attached pictures just Incase anyone has the same issue.
O**.
Excelente
C**N
Sa fait tres bien facile a instaler
R**B
Worked well
A**R
Great fit. Made by Denso so it was expected. Good shipper.
D**K
For 2004 toyota echo. I ordered this along with a condenser not knowing it already had one installed. However it was tiny and cheap looking so I'm very glad I purchased this as well for better ac performance
Trustpilot
1 month ago
3 weeks ago