Description
- [EL4 for Xbox Controller] - 4x Replacement Analog Joystick widely used in Xbox Wireless Controller: Xbox One, One S, X and Elite Series 1. Also used with the latest Xbox Series S | X controllers. OEM repair parts are made by ALPS and come with a 10K side trim pot resistor. (Hole effect version, see B0CYBWQWTB )
- [COMPATIBILITY] - This version of the analog joystick comes with a light grey bottom plate. Lock in a specific direction when not attached to the controller cover. It comes with 14 prongs as the PS4 version. However, they are slightly different from each other. Use this EL4 for Xbox. Note: EL4 will not work with old Xbox 360. Choose EL5 for Xbox Elite Series 2
- 【ADDITIONAL GIFT DRIFT CORRECT PCB】 - Joystick drift is a common problem. New joystick may also drift Potentiometers were born without precision. Due to the wear of carbon film, spring fatigue, and material extension, it was not centered. Dirt, moisture and drops can make it even worse. To solve the problem of unidirectional drifting, we packaged PCB as a gift. Simply adjust the variable resistor to eliminate drift
- 【Time to Replace】- If you have problems with controllers drifting, creep, statter, blind spot, dead zone, dead zone, click or not placed in the middle of the click, you need to replace the analog joystick for years of wear. OEM genuine repair parts ensure accuracy and extend life
- 【DIY Reminder】- With 14 prongs, soldering and soldering the entire module is a lot of skill. To solve most of the joystick problems, we recommend replacing the potentiometer first. If you want to remove the entire joystick module from the PCB, we recommend two ways. 1. Product ID: B0BK7169M8 Solder Removal Kit 2. Or you can cut 14 prongs one by one with a wire cutter
Please go to B0CYBWQWTB for the Hall Effect version for Xbox Please take a look at product ID: B0BK7169M8 for the desoldering kit EL4 for Xbox Controller 4x Replacement analog joystick widely used in Xbox wireless controllers: Xbox One, One S and X and Elite Series 1. It is also used in new Xbox Series S|X controllers. The OEM repair part was made by ALPS and come with 10K side trim pot resistors. This version of analog joystick come in light gray bottom plate. It locks in certain direction when not sit in controller cover. It comes with the same 14prongs. structure as PS4 Version. However, they're slightly different from each other. Please use this EL4 for Xbox. Be noticed: EL4 does not work with older Xbox 360. Choose EL5 for Elite Series 2.
