Our 3D touch is an auto leveling sensor for 3D printers that can precisely measure the tilt of your print surface. It can greatly improve the printing precision of your 3D printer, and it is compatible with most prusa I3 3D printers. Note: 3D touch car leveling sensor is not plug_and_play; you will need to do some modification to your firmware and for some control board, you may need to do some soldering work to the connector. We have prepared the pins for you. Specifications: Voltage: 5 V. Current: 15 mA. Max. Current: 300 mA. Cable length: 150 mm. Net weight: 10 g. Shipping weight: 25 g. Operate condition: 3DTouch can be operated in the following condition. One I/O for control (PWM or Software PWM) One I/O for Z min (Z sample) GND and +5V power Wiring: 3-pin: brown (-, GND), red (+5V), orange (control signal) 2-pin: black (-, GND), white (Z min) Caution: Additional power supply will be needed in case your board does not supply enough amperage. Electronic devices can be damaged or even destroyed if connected to wrong polarity. [wrong terminal connect to 5V(+) and GND(-)] Pulling/pushing hard on the push-pin can damage 3DTouch and make it less accurate. Fix push-pin with locking paint after reassembling or adjusting core. Do not remove or deform elastic material attached to the push-pin.
J**N
Faulty Unit (Geeetech refuse to replace)
Your browser does not support HTML5 video. This unit was purchased from another vender, but unit was purchased in dec 2018 and in march failed. Contacted geeetech who initially stated they would resolve issue then quickly backtracked! I've since bought BLTouch genuine and can physically tell difference in quality and magnetic strength of probe. also results from probe varied quite a bit on geeetech solution but results more consistent on genuine unit.
Trustpilot
1 day ago
1 month ago
